Uses of Package
org.lsst.ccs.subsystems.fcs.drivers

Packages that use org.lsst.ccs.subsystems.fcs.drivers

Package	Description
org.lsst.ccs.subsystems.fcs.common	This packages is for the interfaces or abstract classes that are common for all the subpackages.
org.lsst.ccs.subsystems.fcs.drivers	This package is for the software which communicates with the drivers of the real hardware.
org.lsst.ccs.subsystems.fcs.simulation	This package is for the simulators of the Filter Exchanger hardware.
org.lsst.ccs.subsystems.fcs.testbench	This package is for the test bench installed at APC with a PC104 and two Can Open Devices : an ADC and a DAC.

Classes in org.lsst.ccs.subsystems.fcs.drivers used by org.lsst.ccs.subsystems.fcs.common

Class and Description
EmergencyMessageListener Interface for can devices that handle emergency messages.

Classes in org.lsst.ccs.subsystems.fcs.drivers used by org.lsst.ccs.subsystems.fcs.drivers

Class and Description
CanCBXAI814 This is the driver class for the ADC we use in the FCS test bench at APC and in SINGLE FILTER TEST CAN-CBX-AI814.
CanOpenDevice The goal of this class is to factorize all methods commun to all CANopen devices.
CanOpenEPOS A general model for a controller EPOS.
CanOpenEventListener
CanOpenProxy The main job of the class CanOpenProxy is to check that the CANopen devices booted on the CAN bus are the CANopen devices which are listed in the configuration system.
CanOpenSensor14bits This is a Model for a sensor on a can open bus which communicates over Can Open protocol.
EmergencyMessageListener Interface for can devices that handle emergency messages.
MonitorDeviceInterface
PlutoGateway This represents the gateway to the pluto PLC involved in the camera protection system.

Classes in org.lsst.ccs.subsystems.fcs.drivers used by org.lsst.ccs.subsystems.fcs.simulation

Class and Description
CanCBXAI420 This class represents the electronic device used in autochanger to plug the proximity sensor.
CanCBXAI814 This is the driver class for the ADC we use in the FCS test bench at APC and in SINGLE FILTER TEST CAN-CBX-AI814.
CanOpenDevice The goal of this class is to factorize all methods commun to all CANopen devices.
CanOpenEPOS A general model for a controller EPOS.
CanOpenEPOSCarousel
CanOpenEventListener
CanOpenProxy The main job of the class CanOpenProxy is to check that the CANopen devices booted on the CAN bus are the CANopen devices which are listed in the configuration system.
CanOpenSensor14bits This is a Model for a sensor on a can open bus which communicates over Can Open protocol.
CanOpenStrainGauge This class represents the strain gauge Seneca ZC-SG used in the autochanger for ONLINE clamps.
CanOpenTTC580 A model for the CANopen device to read carousel sensors.
EmergencyMessageListener Interface for can devices that handle emergency messages.
LoaderCanOpenProxy A class for Loader when it's in whole Exchange System.
PlutoGateway This represents the gateway to the pluto PLC involved in the camera protection system.

Classes in org.lsst.ccs.subsystems.fcs.drivers used by org.lsst.ccs.subsystems.fcs.testbench

Class and Description
CanOpenDAC This is the driver class for the DAC we use in the FCS test bench: CAN-CBX-AO412
CanOpenThermometer This is a driver for a thermometer we have in the APC test bench.