Package org.lsst.ccs.subsystems.fcs.singlefiltertest

This package is for the Single Filter Test control software.

See: Description

Interface Summary

Interface	Description
TruckMotorListener	An interface to be notified when something happens to the sft truck motor.

Class Summary

Class	Description
BasicAutoChanger	An abstract changer module without a fliprail, without online clamp, and without a motor.
CanOpenLatchActuator	Used only for the single-filter-test hardware.
CanOpenTruckMotor	This represents the motor that moves an autochanger truck along its rail in the single-filter-test test bench.
CompactIO	This represents a device we use in FCS for to connect our numeric sensors(CAN-CBX-DIO8).
LatchActuator	For the single-filter-test, a model for the actuator which opens and close the latches to release or hold a filter.
SftAutoChanger	This class is for the Single Filter Test autochanger.
SftCarousel	This class is for the Single Filter Test carousel.
SftFilterLatch	This is a model for a latch.
SftMain	The Main Module for the single-filter-test.
SftTruckMotor
SftUtils	This class's goal is to create the Objects needed for the GUI and the Status Bus in the package single-filter-test.
SimuCompactIO	Used only in single-filter-test simulation to simulate the devices through we read latches sensors.
SimuLatchActuator	A simulated actuator for the latch used in single-filter-test.
SimuTruckMotor	To simulate a motor which moves a truck in the autochanger.
Truck	A truck is a mobile part in the autochanger.

Package org.lsst.ccs.subsystems.fcs.singlefiltertest Description

This package is for the Single Filter Test control software. The Single Filter Test is a test bench to test mainly the clamps which hold a filter on the carousel and the latches which hold a filter in the autochanger truck. This test bench is going to be assembly in Marseille in the CCPM laboratory, a IN2P3 lab. It contains a fake carousel which cannot rotate with two clamps, a very simple autochanger truck with two latches a dummy filter. This is a hardware and software test, as we are going to test both. The mechanical team want to test a sequence of operation which consists in moving a filter from standby position on the carousel to an higher position (online position) and test the transition of the filter from the carousel to the autochanger and vice-versa. This sequence of operation can be done many times. The number of times can be given by the operator at the console. The devices to control are :

• a motor to move the autochanger trucks
• a filter presence sensorfor each clamp
• an actuator for each clamp to unlock or release the clamp
• sensors to know if the clamp is locked or unlocked : one for one side and two for the other side.

After the construction of the camera, this package will not be used anymore.