Package org.lsst.ccs.subsystems.fcs.testbench

This package is for the test bench installed at APC with a PC104 and two Can Open Devices : an ADC and a DAC.

See: Description

Interface Summary

Interface	Description
Led	Use in APC test bench

Class Summary

Class	Description
APCTestBench2CanBusMain	Thois soft is to test the FCS with 2 CAN BUS : - one for the carousel and the autochanger - one for the loader
APCTestBenchMainModule	This is the main module for the control software of the APC test bench.
BridgeForAPCTestBench	This is the bridge to the can open hardware in the APC testbench.
BridgeForCPPMTestBench	This class represents the list of the hardware on the CPPM testbench.
BridgeForLPSCTestBench	This class is a list of hardware on the LPSC test bench.
BridgeToChanger	In the APC test bench with 2 Can Bus, this is the bridge to the changer harwdare (only a DAC).
BridgeToLoader	This class is used by the APC test bench to test the connection and disconnection of the loader CANbus.
CanOpenLED	Used in APC TEST BENCH only.
CPPMTestBenchMainModule	This subsystem is to read some sensors in CPPM through the pluto gateway.
CPPMTestBenchWholeMainModule
LoaderTestBenchMainModule	This is the Main Module for the LPSC test bench control software.
LPNHETestBenchMainModule	This is the main module for the control software of the LPNHE test bench.
TbUtils	To creates Objects for GUI and Status Bus for the test benches.

Package org.lsst.ccs.subsystems.fcs.testbench Description

This package is for the test bench installed at APC with a PC104 and two Can Open Devices : an ADC and a DAC. It is also for the test bench installed at LPNHE with a PC104 and a clamp actuator which is a Maxon motor. The LPNHE test bench has the same goal than the APC test bench and its design is similar. Its purpose is to test the communications between the CCS and the control software of the test bench. The control software of the test bench has 2 parts : - a Modular Subsystem, which is a subsystem of the CCS and written with the CCS framework - a C program which handle the can open devices : it translate the commands comming from the Modular Subsystem in commands that the ADC and the DAC can understand. To do this translation, it uses the open source C library canfestival.. The PC104 has 2 can bus interfaces and is connected to one or two Can Open device. The PC104 with its can bus interfaces is a Can Open Master Device and the 2 other devices on the Can Bus are Can OPen Slave Can Open Device. The APC test bench is made of one PC104 and 2 can open devives : - a 8 analog inputs (CAN_CBX_AI814) - a 4 analog outputs (CAN_CBX_AO412) A thermometer is connected to the analog inputs and a led is connected to the analog output. One of the OUTPUT of the DAC is connected to the INPUT of the APC, so we can test if the value we write on the DAC is the same value we read on the ADC With the TestBenchMainModule, we can read the temperature, turn on or off the led or start an automatic mode where the temperature is read every tickmillis seconds. When the temperature reachs a given value, it turns the led on, otherwise, it turns the led off. This package should not survive after camera construction. The communications with the Can OPen devices are done by the C programm, testadcdac, which relies on the canfestival C-library. The Wrapper and the TestBenchMainModule communicates over a TCPIP connection.